Publicité
Les langues disponibles
Les langues disponibles
Charging the Battery
∙ Charge the battery regularly, especially
after any long period without use. This
extends battery life and ensures the
longest possible processing cycles.
∙ During the charging process, the
appliance cannot be used.
∙ Plug the power adapter of the included
power supply unit into the socket on the
handle.
∙ Connect the power adapter supplied to
the power socket.
∙ The LEDs should start to flash.
∙ When the battery is fully charged, all
LEDs light up permanently. When the
battery is empty, the charging process
takes approximately 2 hours.
∙ Unplug the power supply unit from the
power socket.
∙ Take the power adapter of the power
supply unit out of the connection socket
for the appliance.
LED indication
The six LEDs on the handle indicate the
battery charge level:
Charging:
∙ When the battery is low, the rear LEDs
flash; when the battery is medium, the
middle LEDs flash; and when the battery
is high, the front LEDs flash.
∙ The more LEDs that are permanently lit,
the higher the charge level.
∙ When all LEDs light up permanently, the
battery is fully charged.
Operation:
∙ The fewer LEDs that are lit, the lower
the charge level.
∙ When the battery power is below 20%,
910142 G24M
the rear two LEDs appear flashing.
Overload:
∙ If all LEDs flash simultaneously, the
appliance is overloaded and switches
off. You can switch the appliance on
again immediately if the battery has
sufficient power. When the last two
LEDs flash, charge the appliance first.
∙ If necessary, add less dough to prevent
the appliance from switching off again.
Operation
∙ Insert the selected attachments into
the openings on the underside of the
blender and push them gently upwards
until they lock into place.
∙ Depending on the quantity of
ingredients, use a sufficiently deep bowl.
∙ Any bowl, round container or glass is
suitable, provided it is scratch-proof and
the attachments can rotate freely inside.
∙ Once the attachments are fitted, take
the blender in hand and position the
attachments inside the container filled
with the ingredients.
∙ Use the switch to turn the appliance on.
∙ Once processing is finished, or if you
wish to interrupt the operation, switch off
first and wait until the motor has come
to a complete standstill before lifting the
attachments out of the mixture.
Ejecting the attachments
∙ Always switch off the appliance from
before any attachments are ejected.
∙ The attachments are automatically
detached PUSH when the release
button is pressed.
16/31
Publicité
