Gaggenau RF 200 Notice D'utilisation page 37

Basic operation
Basic operation
You can find out everything you need
to know about operating your appli-
ance here.
Switching on the appliance
Press .
1.
The appliance begins to cool.
a
Switch off the warning signal with
2.
.
goes out as soon as the set
a
temperature has been reached.
Set the required temperature.
3.
→ Page 37
Operating tips
Once you have switched on the
¡
appliance, the set temperature is
only reached after several hours.
Do not put in any food in the appli-
ance until the temperature is
reached.
The front panels of the housing are
¡
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
When you close the door of the
¡
freezer compartment, a vacuum
may be created and you may not
be able to open the freezer door
again immediately. Wait a moment
until the vacuum is offset.
The refrigeration system may
¡
cause several areas of the freezer
shelves to frost quickly. The frost
has no effect on the function or the
energy consumption of the appli-
ance. If frost or ice thicker than
5 mm has formed on the entire
surface of the freezer shelf, the ap-
pliance must be defrosted.
Switching off the appliance
Press .
▶
The appliance stops cooling.
a
Setting the temperature
After you have switched on the appli-
ance, you can set the temperature.
Setting the freezer compartment
temperature
Use a coin to set the temperature
▶
at the temperature controller.
The higher the number, the lower
the temperature.
The middle setting is recommen-
ded by the factory.
Additional functions
Additional functions
Find out which additional functions
which can be used for your appli-
ance.
Fast freezing
Fast freezing cools the freezer com-
partment as cold as possible. This
freezes food quickly right through to
the centre.
Switch off Fast freezing four to
six hours before placing food weigh-
ing 2 kg or more into the freezer
compartment.
In order to utilise the freezer capacity,
use Fast freezing.
→ "Prerequisites for freezing capa-
city", Page 38
Note: When Fast freezing is switched
on, increased noise may occur.
Switching on Fast freezing
Press .
▶
lights up.
a
Basic operation en
37