HAUG 01.7835.300 Mode D'emploi page 36

6 Troubleshooting
Pos: 9.1 /Bedi enungsanleitungen/F ehler beh eben/Entlad enetz teile/Module Allg emein /001 Fehler b eheb en Einleitung @ 0\mod_1350390750986_ 2848.docx @ 2903 @ 1 @ 1
6 Troubleshooting
Electric shock hazard!
The discharging power pack is operated electrically and generates a
high electric voltage. In the event of any faults, there is a risk of an
electric shock.
• Faults may only be eliminated by a trained and qualified
NOTE:
If the error cannot be removed in this way, return the discharging
power pack and ionizing unit for checking to HAUG GmbH & Co. KG
(the address is provided on the back of the envelope).
Pos: 9.2 /Bedi enungsanleitungen/F ehler beh eben/Entlad enetz teile/Module E N S L LC /005 Tab elle F ehler beh eben @ 2\mod_ 1530000106873_2848.docx @ 30973 @ @ 1
Fault
Ionisation
not available
Pos: 9.3 /Bedi enungsanleitungen/S eitenumbruch @ 0\mod_ 1343041632941_0.docx @ 2959 @ @ 1
36
electrician.
Cause
Power failure
HV not available
The discharging
power pack is
damaged
Ionisation unit is
dirty
Troubleshooting
Inspect the power fuse
Check the fuse of the discharging
power pack.
Inspect the connections on the
discharging power pack.
Use the Combicheck to verify the
HV output of the discharging
power pack. (Accessories/spare
parts, refer page 40)
Shut down the discharging power
pack immediately and secure it to
prevent unintentional restart.
Clean ionisation unit