Publicité
Les langues disponibles
Les langues disponibles
Pos: 7.14 /Bedienungsanleitungen /Installieren/Entlad enetz teile/Module EN S L RLC Digital/040 Anschluss K6 Signalbuchse @ 2\mod_1488288675842_ 2848.docx @ 26339 @ @ 1
8. If required, the signalling
Configuration of K6
signalling socket:
A Relay contact for
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin PE Shield ground
Switching status table for K6 signalling socket
Normal
operation
Internal fault Mains voltage
External
fault
NOTE:
Leave the unused signal socket closed or secure it with the sealing
cap to prevent the ingress of environmental influences. The sealing
cap must be clean, dry and free of grease.
Pos: 7.15 /Bedienungsanleitungen /Installieren/Entlad enetz teile/Module Allg emein /013 Betriebsb ereit @ 0\mod_ 1349958954146_ 2848.docx @ 2895 @ @ 1
9. The discharging power pack is ready for operation.
Pos: 7.16 /Bedienungsanleitungen /S eitenumbruch @ 0\mod_1343041632941_ 0.docx @ 2959 @ @ 1
line K6 can be connected to
the K6 signalling socket.
• The K6 signalling socket
can be used to monitor
the correct function of
the discharging power
pack.
• Relay contact rating:
max. 24 V~ / 35 V=,
max. 50 mA
operational failure
Switching contact
Joint connection relay
NC contact
Not assigned
Not assigned
Not assigned
Operating conditions
Mains voltage
present
present
Mains failure
HV present
HV failure
Not defined
4
Install
Contacts
closed
1 and 2
2 and 3
2 and 3
33
Publicité
