Publicité
Les langues disponibles
Les langues disponibles
4
Install
Pos: 7.9 /Bedi enungsanleitungen/Installieren /Entl adenetzteile/Module EN SL SLC /025 Anschließen @ 1\mod_ 1465908490469_2848.docx @ 20072 @ @ 1
6. Connect the discharging
Pos: 7.10 /Bedienungsanleitungen /Installieren/Entlad enetz teile/Module Allg emein /008 Achtung E IN-AU S-Steck en @ 0\mod_1349940713311_ 2848.docx @ 2890 @ @ 1
When the ionizing unit is plugged in or unplugged while the
discharging power pack is switched on, spark-overs will occur at the
HV connection. This may result in defects in the discharging power
pack.
• Switch off discharging power pack before plugging in/unplugging
Pos: 7.11 /Bedienungsanleitungen /Installieren/Entlad enetz teile/Module Allg emein /009 Ionisationsger ät anschließen @ 0\mod_1349946705235_ 2848.docx @ 2891 @ @ 1
7. Connect the ionizing unit to
Pos: 7.12 /Bedienungsanleitungen /Installieren/Entlad enetz teile/Module Allg emein /010 HINWEIS H S-Anschluss mit Blindstopfen @ 2\mod_ 1519306572879_ 2848.docx @ 30414 @ @ 1
NOTE:
Compliance with maximum connection length specifications is
required.
Use blind plugs to protect the unused HV connection points against
environmental influences. Ensure that the blind plugs are clean, dry
and free of grease.
Pos: 7.13 /Bedienungsanleitungen /S eitenumbruch @ 0\mod_1343041632941_ 0.docx @ 2959 @ @ 1
32
power pack to the supply
voltage. Always connect the
protective earth conductor
(green-yellow) with a
functioning protective earth
of the mains.
• Connecting the PE
conductor via parts of a
machine body is
insufficient.
• L = brown conductor
• N = blue conductor
• PE = green/yellow conductor
Contact and separation spark-overs!
ionizing unit.
the HV terminal of the
discharging power pack.
• Insert the ionizing unit's
HV plug in the HV
terminal of the
discharging power pack
and press the HV cable
until it reaches the stop.
• Screw the screw cap
onto the HV terminal and tighten by hand.
Publicité
