Monitor Audio Silver W-12 Manuel Du Propriétaire page 8

Top Control Panel
1
1. EQ Button
This button has multiple functions, these are listed below:
• It wakes the W-12 from standby with a single press
• A long press (5 seconds) puts the W-12 into standby mode.
• When operational, it cycles through three different EQ profiles.
• The LED indicates selected EQ profile (while operational) and other states
depending on mode and colour. A colour matrix can be found below.
WHITE -
BLUE -
PINK -
GREEN -
CYAN -
RED -
YELLOW & OTHER COLOUR - Fault mode (when flashing with other colour. See
below.)
Further information on the EQ profiles can be found on page 10.
2. Calibration Button
The calibration button is used to enter 'Automatic Position Correction (APC). This is
used to take SPL measurements of the room and to correct the frequency response
of the speaker to offset any colouration effects of the environment.
Refer to page 8 for further information on running the APC.
3. Microphone socket
Used to set the sub woofer up to adjust for the room acoustics.
Refer to page 8
All manuals and user guides at all-guides.com
4
Boot sequence
EQ Profile 1 (Movies)
EQ Profile 2 (Music)
EQ Profile 3 (Impact)
Room Calibration In Progress
Factory Reset (Static)
6
2
3