Publicité
Les langues disponibles
Les langues disponibles
Connected to an AV Receiver
The majority of AV amplifiers have automatic setup systems. If your amp has an auto set
up procedure, run this now with the volume set to around 10 - 12 o'clock, and the power
mode switch in the On position.
When the auto set up is complete check the settings on the AV amp for the sub woofer
to ensure they are correct. The crossover frequency should be roughly the same as in
the table on page 4 and the level should be no more/ less than +/- 3dB. If not we would
suggest adjusting accordingly.
Now play a variety of music/ film excerpts that you are familiar with gradually increasing
the volume to an average listening level once you are sure everything is working correctly.
Connected to a Stereo Amplifier
Stereo L & R input may be required if using a 2-channel stereo amplifier, or an amplifier
with no LFE output. Connect 2 x interconnect cables (left and right) from an amplifier to
connections marked Inputs L & R.
With the pre/ integrated amplifier set to a low level, set the subwoofer up using the
suggested guide below before playing any music/ test tones.
•
Set the volume to around 10 o'clock (Page 6)
•
Frequency should be set in accordance to your main speakers (refer to the table on
Page 4)
•
Phase to 0 (Page 4)
Now play some familiar music and gradually adjust the volume and/ or the frequency until
happy with the integration and balance of the sub woofer with the rest of the system.
All manuals and user guides at all-guides.com
9
Publicité
