Publicité
Les langues disponibles
Les langues disponibles
Trouble Shooting
Fault Mode
The Silver W-12 can display 3 individual faults codes. Each fault mode makes the LED in
the EQ Button alternate between yellow and another colour; red, green or blue.
Mode 1 - Power supply unit issue
Yellow/Red flashing
Mode 2 - Power amplifier issue
Yellow/Green flashing
If these faults occur, try carrying out a power cycle first, leaving the mains power removed
for at least 5 minutes. If that doesn't solve the error try a factory reset.
If it still does not output a signal or the fault mode is still present, please contact your local
dealer/ distributor or Monitor Audio immediately.
Factory Reset
If any problems or glitches occur, the first port of call will be a factory reset. This is
actuated via a long press of button 1 and button 2 simultaneously.
This will reset -
•
The current saved EQ (Resets to profile 1)
•
Any saved microphone calibration data
•
Any saved APC filter profiles
Firmware Version
A short press of both buttons causes the system to report its current firmware version by
blinking the LED's within the buttons.
The LED within the EQ Button denotes a 1 and the LED within the Calibration button
denotes a 0. Add up the pattern and pauses to determine the firmware version, for
example:
Firmware version 2.1.1 would be 2 x EQ LED - Pause - 1 x EQ LED - Pause - 1 x EQ LED
Firmware version 3.0.0 would be 3 x EQ LED - Pause - 1 x Calibration LED - Pause -
1 x Calibration LED.
All manuals and user guides at all-guides.com
12
Publicité
