Meec tools 025356 Traduction Des Instructions D'origine page 26

EN
WIRE PULLING POWER, WIRE
LENGTH AND NUMBER OF LAYERS
permitted wire
Bearing pulling power
1
2
3
4
5
6
ASSEMBLY
The winch's mounting hole pattern follows
the standard for this type of winch. A large
selection of mounting kits for different vehicles
can therefore be used. The fastener to be used
must be mounted on a flat surface, so that the
winch's three main components (motor, gear
reduction, and drum) are properly aligned.
Correct alignment is necessary for uniform
distribution of the winch forces.
1. Mount the fairlead (A) on the bracket (B)
using two M8 x 20 screws, flat washers,
lock washers, and M8 nuts. Note that
the screws should be put in from the
inside of the bracket. Otherwise, there
will be insufficient clearance, making
it impossible to install the winch in the
bracket.
2. Fit the winch (C) on the bracket. To
do this, the winch drum must first be
disengaged (place the clutch lever (D) in
the CLUTCH OUT position) and the winch
wire pulled out a few decimeters and
threaded through the slot in the front of
the bracket and through the fairlead.
3. Screw the winch on the bracket using
two M8 x 35 screws, flat washers, lock
washers, and M8 nuts.
26
Nominal Total wire
length on
drum
8.9 kN 2.0 m
7.3 kN 4.3 m
6.1 kN 6.8 m
5.3 kN 9.5 m
4.7 kN 12.5 m
4.2 kN 15.0 m
4. Connect the cables (E) to the battery and
winch motor (F).
5. Fit the hook on the wire by removing
the clevis pin, fitting the hook onto the
wire's eyelet, and then reinserting the pin
through the hook and the wire eyelet.
6. Check the direction of rotation of the
drum:
7. Disengage the drum by placing the clutch
lever in the CLUTCH OUT position.
8. Pull out a length of wire from the drum
and then engage the drum by placing the
clutch lever in the CLUTCH IN position.
9. Press the power switch to feed out the
wire. If the winch drum rotates and feeds
out more cable, the connections have
been done correctly. However, if the winch
drum pulls in the wire instead, the motor is
connected with the wrong polarity – reverse
the cables on the motor's terminal block.
Check the direction of rotation again.
FIG. 1
WARNING!
• Batteries contain and can emit
flammable and explosive gas.
• Wear safety glasses when connecting
and do not handle batteries with wet
hands, or when wearing jewellery on
your hands – risk of severe burn injuries.
• Do not lean over the battery during
connection.
USE
1. Disengage the drum by placing the clutch
lever in the CLUTCH OUT position.
2. Grip the wire, pull out the required length,
and connect the wire to the object to be
winched.
IMPORTANT:
Check that there are at least five rounds
of wire on the drum before the winch wire