Hilti Nuron SC 6WL-22 Notice D'utilisation Originale page 19

5.7 Adjusting the cutting depth
1. Release the cutting depth adjustment clamping lever (1).
2. Lift the product in a scissoring movement and set the cutting depth (2).
3. Tighten the cutting depth adjustment clamping lever (3).
The cutting depth should always be set to a depth approx. 5 to 10 mm greater than the thickness
of the material to be cut.
5.8 Setting cutting angle for bevel cuts
You can set the bevel to a cutting angle between 0° and 53°. The bevel angle preselector enables you
to preset the maximum selectable angle to 22.5° or 45°.
1. If applicable, set a maximum angle by means of the bevel angle preselector.
2. Release the bevel angle preselector clamping lever (1).
3. Swivel the product to the desired bevel cutting angle (2).
4. Lock the product at the set bevel cutting angle with the clamping lever (3).
5.9 Installing parallel guide
1. Release the clamping lever (1).
2. Push the parallel guide into the base plate.
▶ You can adjust the cutting width to suit your application (2).
3. Close the clamping lever.
5.10 Installing guide rail adapter (accessory)
1. Remove the parallel guide, if fitted.
2. Hook the base plate into the rear retaining lugs of the guide rail adapter (1).
3. Set the base plate down on the guide rail adapter (2).
▶ The base plate is flush on the guide rail adapter.
4. Lock the guide rail adapter by pressing in the two sliders (3) as far as they will go.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Switching on or off
Switching on
1. Press and hold down the switch-on interlock and press the on/off button.
▶ You can release the switch-on interlock as soon as you have the on/off switch held down.
Switching off
2. Release the on/off switch.
▶ The switch-on interlock jumps automatically into the locked position.
6.2 Dust and chips management
Sawing with dust extractor:
•
Connect the suction hose to the dust removal connector and follow the instructions in the operating
instructions for the dust extractor.
Sawing with dust bag:
•
Connect the dust bag with the adapter to the dust removal connector for dust extractor.
You can also operate the product without dust extractor or dust bag. Make sure that sawdust and
chips can be ejected without obstruction.
*2359562*
4
7
5
6
2359562 English 13