Publicité
Les langues disponibles
Les langues disponibles
STEP 10:
(SEE FIGURE 10)
•
Place the two angle lock bars together so that all holes
are aligned. Assemble a 3/8" x 1-1/4" carriage bolt and
a 3/8" nylock nut in the top hole. Be sure to insert the
bolt from the side indicated. Finger tighten only.
•
Insert the round hook end of the angle lock spring up
through the hole in bracket (a).
•
Hold the angle lock bars so that the square holes are
at the top. Insert the straight hook end of the angle lock
spring through the middle hole in both angle lock bars.
•
Insert the angle lock bars down through the slot in
the channel. Underneath the channel, place a 1" long
spacer on each side of the angle lock bars and insert
a 1/4" x 3-1/4" bolt through the channel, the angle
lock bars and the spacers. Secure the bolt with a 1/4"
nylock nut.Tighten so that lock bars can pivot freely.
•
At this time tighten the 3/8" carriage bolt and nylon
lock nut previously assembled to angle lock bars.
NoTE: When the angle lock bars are pulled back, the
pivot plate should unlock and be free to pivot.
3/8" NYLOCK
NUT (I)
1/4" NYLOCK
NUT (G)
CHANNEL
1" SPACERS (U)
FIGURE 10
STEP 11:
(SEE FIGURE 11)
•
Use a hammer to tap a 3/8" palnut onto one end of the
spring mount rod. Insert the rod through the rear set of
holes in the pivot plate. Support the assembled end of
the spring mount rod on a block of wood, and tap the
remaining 3/8" palnut onto the other end of the rod.
3/8" PALNUT (P)
3/8" PALNUT (P)
FIGURE 11
ENGLISH
3/8"x 1-1/4"
CARRIAGE BOLT (E)
(a)
ANGLE
LOCK
SPRING (X)
ANGLE
LOCK BARS
1/4" x 3-1/4"
HEX BOLT (A)
(Right Hand Side View)
SPRING
MOUNT
ROD (Z)
PIVOT
PLATE
(Top View)
STEP 12:
(SEE FIGURE 12)
•
Assemble a 3/8" x 1-1/4" carriage bolt through the square
hole in the cable mount bracket and through the square
hole in the angle lock bars as shown. (The carriage bolts
should face in opposite directions.) Using pliers hold the
cable mount bracket in position, angling down towards
the L.H. hole in the channel as shown. Secure with a 3/8"
nylock nut. Tighten. Refer also to figure 14 for the correct
angle for the cable mount bracket.
3/8" x 1-1/4"
CARRIAGE BOLT (E)
ALIGN CABLE
MOUNT BRACKET (W)
WITH L.H. HOLE
3/8" NYLOCK
NUT (I)
FIGURE 12
STEP 13:
(SEE FIGURE 13)
•
Select the end of the control cable that has no rubber
cap. Assemble one 5/16" jam nut approximately 3/4"
onto the threaded end of the control cable. Assemble
the threaded cable end through the round hole in
the cable mount bracket as shown and secure with
another 5/16" jam nut. Tighten.
NoTE: Some adjustment of jam nuts may be required
after blade assembly is completed.
CABLE MOUNT
BRACKET
5/16" JAM NUT (J)
CHANNEL ASSEMBLY
FIGURE 13
9
ANGLE
LOCK
BARS
FRONT
(Right Hand Side View)
3/4"
5/16" JAM NUT (J)
REAR
(Left Hand Side View)
Publicité
