Publicité
Les langues disponibles
Les langues disponibles
TooLS REQUIRED FoR ASSEMBLY
(1)
Pliers
(1)
Hammer
(1)
Adjustable Wrench (or socket set)
(1)
9/16" Open End or Box End Wrench
(2)
7/16" Open End or Box End Wrench
(2)
1/2" Open End or Box End Wrench
REMoVAL oF PARTS FRoM CARToN
•
Remove the loose parts and the hardware packages
from the carton. Lay out all parts and hardware and
identify using the illustrations on pages 2 and 3.
IMPoRTANT: You will not need all of the parts supplied
with your blade. Dispose of unused parts after you have
finished assembling the blade.
NoTE: Right hand (R.H.) and left hand (L.H.) are
determined from the operators position while seated on
the tractor.
CAUTIoN: Do not begin assembling until
the tractor engine, muffler and exhaust
deflector have been allowed to cool off.
TRACToR PREPARATIoN
•
Allow engine, muffler and exhaust deflector to cool
before beginning.
•
Remove the hood from the tractor for better access.
•
Remove the mower deck from the tractor. Refer to the
instructions in your tractor owner's manual.
•
Remove any front mounted attachment such as a
bumper. Save all parts for re-installation.
•
Remove any wiring from the area of the tractor frame
where the frame brackets will be attached. Reinstall
the wiring with the provided plastic tie.
•
If necessary, temporarily remove the browning shield
from the front of the tractor for better access.
ENGLISH
ASSEMBLY
SKIP To STEP 3 IF YoUR TRACToR HAS
Two FRoNT BRACKETS FoR ATTACHING
THE MowER DECK.
USE THE INSTRUCTIoNS IN STEP 1 IF YoUR
TRACToR HAS A SINGLE FRoNT BRACKET
FoR ATTACHING THE MowER DECK
STEP 1:
(SEE FIGURE 1)
Refer to page 6 for examples of how to attach the Frame
Brackets to some other tractor models.
•
Hold the frame bracket so that the two holes are at
the bottom and place it against the side of the tractor
frame in front of the front axle. Align two upper holes
in the bracket with two holes in the tractor frame. Turn
the bracket over if necessary. Attach the bracket using
the appropriate hardware.
SEARS 917 SERIES TRACToR FRAME
3/8" NYLOCK
NUT (I)
FIGURE 1A
JoHN DEERE LT TRACToR FRAME
5/16" x 1"
HEX BOLTS (C)
FIGURE 1B
4
3/8" x 1"
CARRIAGE BOLT (F)
FRAME BRACKET
3/8" LOCK WASHER (R)
3/8" x 1" HEX BOLT (Q)
5/16" NYLOCK
NUTS (H)
FRAME
BRACKETS
Publicité
