Publicité
Les langues disponibles
Les langues disponibles
STEP 14:
(SEE FIGURE 14)
•
Assemble ball end of control cable up through hole in
cable end fitting and pull until ball slips inside curled
edge of fitting as shown. If ball won't slip under edge
of curl it will need to be inserted through open end of
curl.
•
Assemble a 1/4" x 1-1/4" hex bolt down through the
cable end fitting, the 5/8" long spacer and the left
hand hole in the channel assembly. Secure with a
1/4" nylock nut. Tighten.
NoTE: Make sure the cable mount bracket is aligned with
the cable end fitting as shown to prevent binding of cable.
Attach the other end of the control cable in a later step.
CABLE END
FITTING
1/4" NYLOCK NUT (G)
FIGURE 14
STEP 15:
(SEE FIGURE 15)
•
To attach the blade to the channel assembly, align
the notched holes in the pivot plate with the notched
holes in the blade. Insert a 1/8" x 1-1/4" cotter pin
down through the hole at the bend in the blade pivot
shaft. Spread the ends of the pin. From the left side
insert the blade pivot shaft, bend facing up, through
the notched holes. Secure the shaft with another 1/8"
x 1-1/4" cotter pin through the end hole in the shaft.
Spread the ends of the pin.
•
Remove the plastic cap and one 3/8" hex nut from the
bolt in the blade adjust spring. Adjust the remaining
3/8" hex nut down approximately 1" onto the bolt
threads. Hook the spring over the spring mount rod
as shown. Place the bolt up through the hole in the
top edge of the blade and reassemble the other 3/8"
hex nut and tighten down against the top edge of the
blade. Replace the plastic cap over the end of the bolt
threads.
ENGLISH
1/4" x 1-1/4"
HEX BOLT (B)
5/8" SPACER (T)
CHANNEL
ASSEMBLY
HOLE
REAR
(Left Hand Side View)
1/8" x 1-1/4"
COTTER
PIN (O)
BLADE
PIVOT
SHAFT
SPRING
MOUNT
ROD (Z)
PIVOT PLATE
FIGURE 15
STEP 16:
(SEE FIGURE 16)
•
Assemble the 1/2" washer onto the channel pivot pin.
•
Attach the channel assembly to the tractor by placing
the end of the channel assembly up inside the
pivot support bracket on the tractor. Align the hole
in the pivot support bracket with the second hole
in the channel assembly. Insert the channel pivot
pin through the aligned holes from the left side and
secure with a small hairpin cotter pushed all the way
through to the loop end.
NoTE: All hairpin cotters on this snow blade should be
pushed through to their loop end.
PIVOT SUPPORT
BRACKET
HOLE IN END OF
CHANNEL ASSEMBLY
FIGURE 16
10
PLASTIC
CAP
3/8" HEX NUT
(TOP)
3/8" HEX NUT
(BOTTOM)
BLADE
BLADE
ADJUST
SPRING
1/8" x 1-1/4"
COTTER PIN (O)
(Right Hand Side View)
1/2" WASHER (S)
CHANNEL
PIVOT PIN (AA)
CHANNEL
ASSEMBLY
SMALL HAIRPIN
COTTER (N)
(Right Hand Side View)
Publicité
