Publicité
Step 4
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the ENDS (A)
until the shoulders of the SCREWS rest on the surfaces of the ENDS.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (C) onto the ENDS (A). Line up the grooves
in the MOLDINGS over the heads of the SCREWS in the ENDS.
å
NOTE: If the MOLDINGS come up off of the SCREWS, remove them
and slide them on again.
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Shoulder
C
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
Page 8
These edges
should be even.
A
32S
A
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Shoulder
428724
These edges
should be even.
C
www.sauder.com/service
Publicité
