Publicité
Step 10
å
NOTE: You will need a tape measure in this step.
å
Unfold the BACK (G) and lay it over the lower edges of the REAR LEGS (H and J) as shown in Diagrams 1 and 2. The
back should be against the TOP (K2).
å
Diagrams 3 and 4: Place the bead of the nail holder down between the BACK (G) and REAR LEGS (J and H) 2" from
the corner. Place a NAIL (1N) into the nail slot of the nail holder. Tap the nail through the BACK and into lower edge
of the REAR LEGS. Remove the nail holder from the nail and completely tap the nail in with your hammer. Finish
fastening the BACK to the REAR LEGS with the hammer and nail holder placing nails approximately 5-1/2" apart.
å
Diagram 5: Fasten the BACK (G) to the BRACE (F). Use three CLIPS (67G) and three BLACK 9/16" LARGE
HEAD SCREWS (1S).
å
NOTE: The CLIPS should wrap around the edges of the BACKS and the teeth
of the CLIPS should bite into the BRACES as you tighten the screws.
3.
2"
Bead
Lower edge
2.
J
BLACK 9/16" LARGE HEAD SCREW
(3 used in this step)
Page 14
J
F
5.
67G
(3 used)
1S
K2
G
H
1.
H
Lower edge
NAIL
(12 used in this step)
428724
Offset edge
Nail
holder
Bead
4.
2"
Bead
1N
www.sauder.com/service
Nail slot
Publicité
