Candy FCXP615X/E Notice D'emploi Et D'installation page 8

4.3 Setting The Correct Time
00:00
ATTENTION: The oven will only operate providing the clock is set.
4.4 Use Of Touch Control Clock Programmer
HOW TO ACTIVATE IT HOW TO SWITCH ITOFF
FUNCTION
•Child Lock function is
activated by touching Set (+)
for a minimum of 5 seconds.
From this moment on all
KEY LOCK
other function are locked and
the display will flash STOP
and preset time
intermittently.
•Push the central button
MINUTE
1 times
MINDER
•Press the buttons "-" "+"
to set the required time
•Release all the buttons
• Push the central button 2
times
COOKING
• Press the buttons "-" or "+"to
TIME
set the lenght of cooking
required
• Release all buttons
• Set the cooking function with
the oven function selector
•Push the central button 3
times •Press the buttons "-"
"+" to set the time at which you
wish the oven to switch off
•Release the buttons
•Set the cooking function with
the oven function selector
END OF
COOKING
select
•Child Lock function is
deactivated by touching
touchpad Set (+) again for a
minimum of 5 seconds. From
this moment on all functions
are selectable again.
•When the set time as elapsed
an audible alarm is activated
(this alarm will stop on its own,
however it can be stopped
immediately by pressing the
button) SELECT.
•When the time is elapsed the
oven will switch off
automatically.
Should you wish to stop
cooking
earlier either turn the function
selector to 0, or set time to
0:00
(SELECT and "-" "+" buttons)
•At the time set, the oven
will switch off. To switch
off manually, turn the oven
f u n c t i o n s e l e c t o r t o
position O.
WARNING : the first operation to carry out after the oven has
been installed or following the interruption of power supply
(this is recognizable the display pulsating and showing
12:00 ) is setting the correct time. This is achieved as follows.
•Push the central button 4 times
•Set time with "-" "+" buttons.
•Release all buttons.
WHAT IT DOES
•Sounds an alarm at the end of
the set time.
•During the process, the
display shows the remaining
time.
• It allows to preset the cooking
time required for the recipe
chosen.
• To check how long is left to run
press the SELECT button 2
Times.
• To alter/change the preset time
press SELECT and "-" "+"
buttons.
•Enables you to set the end of
cooking time
•To check the preset time
the central button 3 times
•To modify the preset time
press buttons SELECT + "-" "+"
EN 08
WHAT IT IS FOR
•Allows to use the oven as
alarm clock (could be activated
either with operating the oven
or with out operating the oven)
•Push any button to stop
the signal. Push the central
button to return to the clock
function
•This function is typically used
with
"cooking time" function.
push
For example if the dish has to be
cooked for 45 minutes and needs
to be ready by 12:30, simply
select the required function, set
the cooking time to 45 minutes
and the end of cooking time to
12:30.
•At the end of the cooking set
time, the oven will switch off
automatically and an audible
alarm will ring.
•Cooking will start automatically
at 11:45 (12:30 minus 45 mins)
and will continue until the pre-set
end-of-cooking-time, when the
oven will switch itself off
automatically.
WARNING.
If the END of cooking is
selected without setting the
length of cooking time, the
oven will start cooking
immediately and it will stop at
the END of cooking time set.