Télécharger Imprimer la page

Signature SRT1002VR Instructions D'installation page 27

Refrigerteur table-top

Publicité

Les langues disponibles

Les langues disponibles

TEST
Clean the parts of the refrigerator with lukewarm water on a soft cloth or
with a neutral detergent and with clear water, then wipe them dry.
Notes: Electric parts of the refrigerator can only be wiped by dry cloth.
Turn the thermostat knob on the "3" position and turn on electricity. The
compressor and the light inside the refrigerator begin to work.
Close the door and wait 30 minutes. If the temperature in the freezer
compartment decreased obviously, it shows that the refrigerator system
works well. When the refrigerator operates for a period of time, the
temperature controller will automatically set the temperature on
conditions that the door is not too often opened.
If the above steps are successful, the trial operations are finished. The
refrigerator works normally.
TEMPERATURE CONTROL
The temperature in the refrigerator compartment and in the freezer
compartment is controlled by the temperature controller installed on the
right side of the refrigerator compartment.
Turn the thermostat knob to regulate the temperature inside the
refrigerator. The marks on the knob are not the exact number of the
degrees of temperature but the temperature grades to "0" from "7". The
first grade corresponds to a forced STOP of the refrigeration and the 7th
grade corresponds to the lowest temperature the refrigerator can
produce. Turn the knob from "1" position to "7" position, the temperature
decreases continuously.
Set the thermostat knob to "3-4" position for a normal use.
COLDEST ZONE IN THE REFRIGERATOR
This symbol indicates the location of the coldest zone of the refrigerator,
the area is bounded below by the glass crisper, and above by the
symbol or the rack positioned at the same height.
To ensure the temperatures in this area, do not change the positioning of
the shelf.
-27-

Publicité

loading