Publicité
Les langues disponibles
Les langues disponibles
Extension Kit
The sleeping space of the bed is extended by
175mm (7") with the addition of this kit. A
bolster mattress is available, measuring 175mm
(7") long by 900mm (35") wide and 125mm (5")
deep.
The standard length of the FloorLine LTC
bed's mattress platorm is 2000mm (783/4 ")
measured internally between the head and foot
pedestal ends (sleeping space).
An optional Bed Extension Kit may be
purchased separately, that when fitted will
lengthen the sleeping space by 175mm (7 ")
to 2175mm (851/2 ") to accommodate taller
people. The overall bed length also extends.
At the foot end of the mattress platform beams,
extension brackets will replace the standard
brackets and an additional mattress platform
panel is fitted over the extension brackets.
A matching mattress bolster is also available as
an optional extra to complement the existing
Human Care mattress.
Extension Kit Contents
2 x Extension Brackets
An Extension Mattress Platform Panel (F8)
4 x Extension Panel Platform Bolts/Nuts
Full instructions to fit the extension.
Required Tools
• A Mains Power Outlet/Power-Point
• A 4mm & a 5mm Allen Key
• A 10mm & 13mm Spanner/Socket Wrench
• A 100mm2 Wood Block to support frame
• A Penknife
Qualified assembly persons must be very
familiar with this User Manual and all
facets of bed assembly and operation.
Fitting the extension kit
1.
Confirm the kit's contents.
2.
Clear sufficient space to conduct
installation and remove the mattress and
any side rails from the bed.
3.
Ensure all castors are aligned and locked
under the outrigger castor beam.
4.
Position the Wood Block directly under the
kneebreak actuator cross beam. This will
support the main bed frame when the
5.
Confirm that mains power is connected.
6.
Using the handset, flatten out/neutralise
the bed functions (Backrest, Kneebreak,
Trendelenburg positions).
7.
Lower the bed carefully down onto the
wood block. The foot end wheel castors
should just gently lift off the floor.
8.
Unplug the mains power cable from the
from the wall and keep cable safe.
9.
Lift the kneebreak panel for easy access
to the Lifting Actuator Cable, the Stepped
Pivot Bolts and Countersunk Bolts.
10. Using a penknife, carefully remove the
white plastic retaining clip, from the Foot
End Actuator Mini-Fit Connector.
NOTE: Do not lose retaining clip!
11. Disconnect the foot end lift actuator cable
from its Mini-Fit Connector.
www.humancaregroup.com
11
Publicité
