Publicité
Liens rapides
Owner's Instruction and Operation Manual
Model Number:
US5517-W
Report #: F22-777
Certified to ASTM E1509-2022 and Certified to
CAN/ULC S627:2023; Complies to CAN ICES-3(B)/
NMB-3(B); Contains IC:23243-WBR1DIPEX
Mobile Home / Transportable Building Approved
* All Pictures In This Manual Are For Illustrative Purposes Only. Actual Product May Vary.
Save These Instructions In A Safe Place For Future Reference.
SAFETY NOTICE: If this heater is not properly installed, a house fire may result. For
your safety, follow the installation instructions. Never use make-shift compromises
during the installation of this heater. Contact local building or fire officials about
permits, restrictions and installation requirements in your area. NEVER OPERATE
THIS PRODUCT WHILE UNATTENDED.
CAUTION! Please read this entire manual before you install or use your new room
heater. Failure to follow instructions may result in property damage, bodily injury, or
even death. Improper Installation Will Void Your Warranty!
WARNING: Before starting your pellet stove remotely with WiFi, it is critical that you
ensure nothing is leaning, draped or near to your stove. All clearances to combustibles
specified in your owner's manual must be maintained at all times. Failure to comply
with this warning could result in a fire and or property damage.
U.S. Environmental Protection Agency
Certified to comply with 2020 particulate
emissions standards.
THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE.
© 2024 United States Stove Company, 227 Industrial Park Rd., South Pittsburg, TN 37380
R
CALIFORNIA PROPOSITION 65 WARNING:
This product can expose you to chemicals including carbon
monoxide, which is known to the State of California to cause
cancer, birth defects, and/or other reproductive harm. For
more information, go to
853996E-1904N
www.P65warnings.ca.gov
Ph. 800-750-2723
Publicité
Manuels Connexes pour United States Stove US5517-W
Sommaire des Matières pour United States Stove US5517-W
- Page 1 State of California to cause cancer, birth defects, and/or other reproductive harm. For emissions standards. more information, go to www.P65warnings.ca.gov THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE. © 2024 United States Stove Company, 227 Industrial Park Rd., South Pittsburg, TN 37380 Ph. 800-750-2723...
- Page 2 / transportable building. Your stove is Certified to ASTM E1509-2022 and Certified to CAN/ULC S627:2023. This manual describes the installation and operation of the U.S. Stove, US5517-W pellet stove. This heater meets the 2020 U.S. Environmental Protection Agency’s crib wood emission limits for wood-heaters sold after May 15, 2020.
- Page 3 Declaration of Completion: As the qualified person responsible for the work described above, I confirm that the appliance as associated work has been installed as per manufacturer’s instructions and following any applicable building and installation codes. Signed: ______________________________________ Print Name: __________________________________Date: ______________ Home Owner: RETAIN THIS INFORMATION FOR FUTURE REFERENCE © 2024 United States Stove Company...
- Page 4 5 Pin Main Wiring Harness. Connect the 4 Pin Wiring Harness to the bottom left-hand corner of the control panel. 5 Pin Main Wiring Harness 4 Pin Fuel Sensor 7 Pin Com Cable © 2024 United States Stove Company...
- Page 5 CORD IN FOOT TRAFFIC AREAS OR PINCH THE CORD UNDER FURNITURE. Your heater should be installed by a qualified NFI (US) or WETT (Canada) technician. To find the nearest qualified installer, go to: https://nficertified.org, https://www.wettinc.ca/ © 2024 United States Stove Company...
- Page 6 (51 mm) to each side of the chimney tee for an interior vertical installation. Canadian Installations require a Ceiling Height To Appliance minimum of 18” [458 mm] beyond the front of the unit and 8” [204 mm] beyond each side of the unit. © 2024 United States Stove Company...
- Page 7 Do not use makeshift bolts that are long enough to go through both a hearth methods or compromise in the installation. pad, if used, and the floor of the home. © 2024 United States Stove Company...
- Page 8 The pellet vent pipe is designed to disassemble for cleaning and should be checked several times during the burning season. The pellet vent pipe is not furnished with the unit and must be purchased separately. © 2024 United States Stove Company...
- Page 9 7. Outside Fresh Air is Mandatory when installing installation must conform to CAN/CSA-B365. this pellet stove room heater in airtight homes and mobile home / transportable buildings. Be sure © 2024 United States Stove Company...
- Page 10 • Do not exceed more than 4ft (1.22m) of pipe on a horizontal run and use as few elbows as possible. If an offset is required, it is better to install 45-degree To Stove elbows rather than 90-degree elbows. © 2024 United States Stove Company...
- Page 11 (the illustration is only an example). Please To Stove 3” PL Vent conform to any local building codes or regulations Clean Out Tee having jurisdiction before you have a qualified installer proceed with this installation. © 2024 United States Stove Company...
- Page 12 The fuel feed system will stop pulling fuel from the hopper ON/OFF HEAT MODE and, once the fire goes out and the heater cools down, the fans will stop running. (POWER) RANGE © 2024 United States Stove Company...
- Page 13 INTO AN ELECTRICAL OUTLET. THESE MOVING Your pellet stove is designed to burn premium hardwood PARTS MAY BEGIN TO MOVE AT ANY TIME pellets that comply with the Pellet Fuels Institute (PFI) WHILE THE STOVE IS PLUGGED IN. © 2024 United States Stove Company...
- Page 14 This Open usually takes about 10 minutes from start-up. IF STOVE RUNS OUT OF PELLETS This stove is fitted with a fuel level sensor that, when © 2024 United States Stove Company...
- Page 15 WHILE THE STOVE IS IN OPERATION. through the burn pot freely. • WE RECOMMEND THAT YOU NOT LET THE HOPPER DROP BELOW 1/4 FULL. © 2024 United States Stove Company...
- Page 16 DO NOT VACUUM HOT ASH. WARNING: FAILURE TO PROPERLY MAINTENANCE THE CLEAN OUTS WILL RESULT IN POOR PERFORMANCE OF THIS STOVE. Lift the left and right panel up and out of the unit. Left Panel © 2024 United States Stove Company...
- Page 17 • Enter the 6 digit verification code that was sent to the previously entered email address. • Provide access to the two permissions requested. • Allow notifications through the phones settings. • The app is ready to add the unit. © 2024 United States Stove Company...
- Page 18 The app and unit are now ready for use. Device Select Device Name & Screen Device Sharing Settings Current Room Temperature Temperature Adjuster Stove Setting Decrease Increase Temperature Temperature Setpoint Setpoint Mode Power ON/OFF Heat Range © 2024 United States Stove Company...
- Page 19 CO monitors the top as well as from the bottom. The creosote should in areas having the potential to generate CO. be removed with a brush specifically designed for the © 2024 United States Stove Company...
- Page 20 5. Re-install the retainer and eight nuts and rope gasket Hopper (end of Empty & using high-temperature silicone to adhere the gasket season) Vacuumed to the door. 6. Never use substitute materials for the glass. © 2024 United States Stove Company...
- Page 21 (18 in) beyond the appliance on any side equipped with a door, and at least 200 mm (8 in) beyond the appliance on DO NOT INSTALL IN AN ALCOVE other sides, shall be protected by a continuous, durable, DO NOT INSTALL IN ANY FIREPLACE © 2024 United States Stove Company...
- Page 22 If the other items check out OK, replace the high limit switch. ATTENTION: THIS WOOD HEATER NEEDS PERIODIC INSPECTION AND REPAIR FOR PROPER OPERATION. IT IS AGAINST FEDERAL REGULATIONS TO OPERATE THIS WOOD HEATER IN A MANNER INCONSISTENT WITH OPERATING INSTRUCTIONS IN THIS MANUAL. © 2024 United States Stove Company...
- Page 23 (you may want to remove the hose entirely off the stove and the air switch first and make sure it is clear). If you hear a click, the air switch is working. BE CAREFUL TOO MUCH VACUUM CAN DAMAGE THE AIR SWITCH. © 2024 United States Stove Company...
- Page 24 The control board is not sending power to the POF There should be a 5-volt (approximately) current going to the thermodisc or other auger system components. POF thermodisc after the stove has been on for 10 minutes. © 2024 United States Stove Company...
- Page 25 Remove the auger motor from the auger shaft and try to run the The auger motor has failed. unit. If the motor will turn the shaft is jammed on something. If the motor will not turn, the motor is bad. © 2024 United States Stove Company...
- Page 26 Circuit board malfunction. board is fine. If there is NOT power being sent to the blower when it shuts off during operation, then you have a bad control board. © 2024 United States Stove Company...
- Page 27 Email to: parts@usstove.com 80781 Auger Motor IN ORDER TO MAINTAIN WARRANTY, COMPONENTS MUST BE REPLACED USING USSC PARTS PURCHASED THROUGH YOUR DEALER OR DIRECTLY FROM USSC. USE OF THIRD PARTY COMPONENTS WILL VOID THE WARRANTY. © 2024 United States Stove Company...
- Page 28 ENSURE THE WIRES ARE CONNECTED TO THE BOTTOM TWO PRONGS OF THE HOPPER SWITCH AS SHOWN. CORRECT WRONG © 2024 United States Stove Company...
- Page 29 Engineer Name: ____________________________________ Engineer Name: ____________________________________ License No.: ________________________________________ License No.: ________________________________________ Company: __________________________________________ Company: __________________________________________ Telephone No.: _____________________________________ Telephone No.: _____________________________________ Stove Inspected: Chimney Swept: Stove Inspected: Chimney Swept: Items Replaced: ____________________________________ Items Replaced: ____________________________________ © 2024 United States Stove Company...
- Page 30 NOTES © 2024 United States Stove Company...
- Page 31 NOTES © 2024 United States Stove Company...