Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6) Use the screws provided to mount
the frame of the push plate to the
actuator.
7) If the wall thickness is less than
1-½" [38mm], break the connecting
rods (both red & blue) at point B.
8) Screw the connecting rods (matching colors) to the actuator and leave ¾" [19mm]
exposed.
9) Slide the push plate from the right
side making sure the tabs are
aligned and flip into the frame.
10) Use the provided tamper
prevention screw to secure the
flush plate by holding down the
right button. Flush the toilet a few
times for each buttons, waiting
about 30 sec. between each flush.
Installation Procedure (continued)
¾ "
2 0
m m
5
A
B
C
Wall thickness
- 1
½
"
3 [
8
m
m
]
B
Publicité
Table des Matières
