Publicité
Les langues disponibles
Les langues disponibles
7. TROUBLESHOOTING
You can solve many common appliance problems easily, saving you the cost of a possible Service Call.
Try the suggestions below to see if you can solve the problem before calling for service.
Appliance does not operate.
Temperature inside the appliance is too warm.
Temperature inside the appliance is too cold.
Vibrations
Moisture forms on inside appliance walls.
Moisture forms on outside of appliance.
The door will not close properly.
TO CONTACT THE AUTHORIZED SERVICE CENTER:
AGI SERVICE
450.963.1303/1.888.651.2534
www.agiservce.ca
Not plugged in. The circuit breaker has tripped or there
is a blown fuse.
Temperature control is set too warm.
control to a cooler setting and allow several hours for
the temperature to stabilize.
Door is kept open too long or is opened too frequently.
Warm air enters the appliance every time the door is
opened. Open the door less often.
The door is not closed completely.
The door gasket does not seal properly.
The appliance has recently been disconnected for a
period of time. 4 hours are required for the appliance
to cool down completely.
Temperature control is set too cold. Turn the control
to a warmer setting and allow several hours for the
temperature to stabilize.
Check to assure that the appliance is on a level surface.
The appliance is touching the wall.
appliance and move it from the wall.
If continued vibration occurs, turn off the appliance and
unplug the power plug.
Dept. for further assistance.
Door is slightly open.
Door is kept open too long, or is opened too frequently.
Open the door less often.
The door is not sealed properly.
Door is slightly open, causing cold air from inside the
appliance to meet warm moist air from outside.
The appliance is not on a level surface.
The gasket is dirty.
25
Turn the
Re-level the
Contact Customer Service
Publicité
