Beamz professional PAR 64 36x3W RGBW LED's IR DMX Manuel D'instructions page 5

Manual Colour Control
To choose a preset colour:
1. Press "MANUAL"
2. Press any of the 10 preset colour
To manually adjust the RGB(W) percentage:
1. Press "MANUAL"
2. Press R, G, B or (W) to choose the LED colour to adjust.
3. Press "+"or "-" to increase or decrease the percentage of the colour
Miscellaneous Operation
To black out the lights:
Press "BLACK OUT" This will turn off all the LED's until the button is pressed again.
To adjust the strobe rate:
1. Press "FLASH"
2. Press "+" or "-"to increase or decrease the flash rate.
3. Press "FLASH" again to turn off the strobe.
To adjust the total brightness:
Press or to increase or decrease the brightness.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light
output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly
dirty surrounding can cause greater accumulation of dirt on the unit's optics.
 Make sure the area below the installation place is free from unwanted persons during servicing
 Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any
deformation
 The mains cables must be in impeccable condition and should be replaced immediately when even a small
problem is detected
 In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.
 Clean with soft cloth using normal glass cleaning fluid.
 Always dry the parts carefully.
 Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
5