Publicité
Les langues disponibles
Les langues disponibles
HOW TO CONTROL
The unit can be linked together in daisy chain as many as you need in master/slave mode to perform the great built-in pre-
programmed lighting shows triggered by music.
In Master/Slave mode refer to the DMX settings below:
Master unit
: when working at Auto-run or Sound Control mode operation
Slave units
: DMX start address MUST be set to d001.
Menu for "IR 1" receive IR remote signal, Menu for "IR 0" stop receive IR remote signal.
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+)
into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
REMOTE CONTROL IR INTRODUCTION
4
Four ways to operation:
A. Master/Slave operation
B. Easy sound active and Auto mode
C. Universal DMX controller
D.IR remote control Master/Slave operation
Automatic Mode
Automatic mode will enable you to run the automatic programs on the
product.
To turn on Automatic mode:
1. Press "AUTO"
2 Press "+" or "-" to choose between the 9 different Auto-programs.
To adjust the speed of the automatic program:
1. Press "SPEED"
2. Press "+" or "-" to increase or decrease the speed of the program.
Sound Active Mode
Sound active mode will enable the product to respond to the music.
To turn on Sound Active mode:
1. Press "SOUND"
2. Press "+" or "-" to choose between the 9 different Auto-programs.
To adjust the speed of the automatic program:
1. Press "SPEED"
2. Press "+" or "-" to increase or decrease the speed of the program.
Publicité
