Aerus Beyond Laundry Pro 2.0 Manuel D'instructions page 4

INSTALLATION REQUIREMENTS
WARNING:
NEVER USE AN EXTENSION CORD
ELECTRICAL REQUIREMENTS
100 - 240 Volt 50/60 Hz 5 AMP (minimum) Fuse or Circuit Breaker.
Laundry Pro 2.0 is equipped with an AC to DC power supply.
WATER REQUIREMENTS
A dynamic water pressure of greater than 20 psi / 1.37 bar and
less than 60 psi / 4.13 bar is required to correctly operate your
Laundry Pro 2.0.
See Cautions below.
CAUTION:
Incoming water pressure must be greater than 20 psi / 1.37 bar. If your
household water pressure is greater than 60 psi / 4.13 bar, you must
install an in-line pressure reducer before installing Laundry Pro 2.0.
Failure to follow these instructions may result in water leakage, property
damage, personal injury, and may void your warranty. Water pressure
of 20 psi / 1.37 bar to 60 psi / 4.13 bar is required to correctly operate
your Laundry Pro 2.0. Low water pressure may prevent your unit from
operating properly and/or cause a failure in your washing machine's
water valve.
5.19" (13.48 cm)
4
17.3" (43.94 cm)
3.69" (9.37 cm)
CAUTION:
We strongly recommend that a licensed plumber installs the
Laundry Pro 2.0
LOCATION CONSIDERATIONS
The Laundry Pro 2.0 must never be installed in areas where water
may freeze since the unit will always maintain some water in the unit,
the water valve, and hose areas. This can cause damage to internal
components. It is also recommended to avoid installation in areas of
high humidity, as it can e ect the operation of the unit.
The washer's water valve may also not shut o completely. Check
the documentation supplied with your washing machine for exact
speci cations. Your washing machine and cold water faucet must be
within 4 feet of the right side of the unit to use the inlet hose provided
with your Laundry Pro 2.0.
TO AVOID THE POSSIBILITY OF WATER DAMAGE, SHOULD A HOSE
LEAK, ALWAYS HAVE FAUCETS ACCESSIBLE AND TURN OFF
FAUCETS WHEN WASHER IS NOT IN USE. DO NOT USE WITH A
CARBON FILTER.
WATER
INLET
WATER
OUTLET