Aerus Beyond Laundry Pro 2.0 Manuel D'instructions page 13

TEMPERATURE CONTROLLING WATER VALVES
Some washers monitor the incoming cold water temperature and adjust too cold of water by adding hot water, even if the water temperature is set to cold. If you
have one of these washers, do not install with the "Y" adapter as it may cause the washer to not operate correctly. Consult your washing machine owner's manual
if needed.
EXTERNAL WATER TAP AVAILABLE SEPARATELY
An optional Laundry Pro 2.0 water tap allows you to run water with hydrogen and oxygen based oxidizers for cleaning surfaces, without the cost or chemical
irritants found in most traditional cleaning products. (ActiveClean Port - 49693-US)
STATUS INDICATIONS
The Laundry Pro 2.0 monitors its operations with a blue LED indicator:
• Unit on = LED on steadily. ("unit on" means whenever water is owing
through the unit).
• ActivePure Cell replacement upcoming (@ approx.. 7500 hours) =
periodic brief LED ash (visual chirp) when unit is o , but goes to steady on
when water is owing through the unit.
• ActivePure Cell replacement required (@ approx. 9000 hours) = periodic
brief LED ash (visual chirp) whether unit is o or on. UV bulb will NOT be
turned on again until cell is replaced.
• UV bulb failure = periodic brief LED ash (visual chirp) – same as
ActivePure Cell replacement required above.
• ActivePure Cell replacement: When replacing the ActivePure Cell, there
is a switch on the main circuit board which must pressed. When this
happens, the LED will blink 3 times (longer than the brief "chirp" ashes
above) and then shut o . This indicates that the ActivePure Cell timer has
been reset to 0. Pressing the button at any time before the 7500 hour mark
*or* before a bulb failure has been detected will NOT reset the timer.
• Leak Alarm: LED will ash in conjunction with alarm beeping.
If this occurs, please contact Customer Service at 800.572.0502
for assistance.
Circuit Board
WARNING:
Electrical Shock Hazard. Disconnect power before
attempting installation or service.
WARNING:
Electrical Shock Hazard. When working with electrical
connections, the appliance and surrounding area should
be clean and dry of any standing water. Failure to follow
these instructions can result in death, re, or electrical
shock.
WARNING:
Do not operate Laundry Pro 2.0 with the front cover
removed or improperly installed. Failure to follow these
instructions can result in severe eye damage, death,
or electrical shock.
Status Indicator Light
13