Aerus Beyond Laundry Pro 2.0 Manuel D'instructions page 12

FOR WASHERS THAT REQUIRE HOT & COLD WATER INPUT
Some washing machine models require water pressure to both the Hot and Cold valves for proper
operation. In some cases, if only the COLD water side is connected, the water valve will not operate
or the washing machine will not ll to the proper level. To solve this problem, the installation of
a "Y" adapter (available at most hardware stores) may be used. The use of the "Y" adapter allows
water to ow equally through both the HOT and COLD water valves. Optional stainless steel hose
(item #: 49701-US) must be installed on the hot water connection. To Install, turn water o at the
valves and disconnect the existing HOT water hose (at the valve and washing machine). Connect
the "Y" adapter to the outlet on your Laundry Pro 2.0, then connect both the optional stainless
steel hose (item #: 49701-US) and Cold hose from your washer to the "Y" adapter (see diagram
below). Operate your washer on the WARM/WARM setting (your Laundry Pro 2.0 will still be using
just cold water).
NOTE:
Your hot source water valve will not have a hose connected to it.
Make sure it is fully turned o . It is recommended you secure a cap
(available at most home improvement stores) to prevent leakage.
NOTE:
The "Y" adapter needs to be purchased locally. Use only a metal adapter.
DO NOT use plastic.
Connect the "Y" adapter to the OUTLET on your
Laundry Pro 2.0. Be sure to hold the tting with
pliers while tightening the adapter.
Disconnect this stainless steel hose from
the OUTLET on your Laundry Pro 2.0, then
connect it to the "Y" adapter.
12
Stainless steel hose supplied
with Laundry Pro 2.0.
Connect to COLD water inlet
on washing machine
CAUTION:
Turn o both water valves (hot and cold)
before disconnecting hoses. Failure to
follow these instructions may result in water
leakage and/or possible injury
from hot water.
CAUTION:
When connecting hoses to your
Laundry Pro 2.0 hand start the hose
connector(s). Using adjustable pliers, nish
tightening hose connector(s).
Connect to household
plumbing COLD water valve
"Y" adapter
Make sure the "Y" adapter
valve is in the on position.
NOTE: Use a metal "Y" adapter.
Do not use plastic
Disconnect the existing hose
from the HOT valve and washing
machine and remove. Replace with
optional stainless
steel hose. Part No.
(not included).
Connect to HOT water inlet
on washing machine
49701-US