Publicité
Les langues disponibles
Les langues disponibles
Tools
you will need
Tape measure
Spirit level
Flat blade screwdriver
Phillips screwdriver
Torx screwdriver
Open-ended wrench
(SW 10 mm, 13 mm)
Pipe wrenches (2)
(if galvanized or iron fittings
are used)
Adjustable wrenches (2)
(If copper fittings are used)
Wire cutter
Wire stripper
Electric drill
1" drill bit or hole saw
I,
J®l
Hammer
Materials
you will need
Min 3/8" OD Copper tubing of sufficient length for your installation.
Shut-off valve and fittings for water supply line.
1 compression nut, 1 compression sleeve, 1 90 ° compression elbow
(3/8" NPT one end).
5/8" ID Heat and Detergent Resistant Rubber Hose and Clamps
(to accomodate drain line).
120 Volt 60 Hz, 15 Amp, 2 Wire with ground, Properly Grounded,
Branch Circuit.
I/2" Strain Relief Bushing for Electrical Supply Cable.
5
Publicité
