Publicité
Les langues disponibles
Les langues disponibles
Drain line
To connect the drain hose to sink, disposer or air gap
use a piece of rubber drain hose.
The rubber drain hose hose must be resistant to heat and detergent
and may be obtained from a plumbing hardware, or automotive
supply outlet.
DO NOT use a drain line or fittings less than 5Is" ID.
The access hole for the drain line should be 1".
Typical drain connections are shown in Fig. 13, 14 and 15.
Fig. 13
Drain connection to sink plumbing
before trap (high loop drain).
IMPORTANT
If no air gap is used and the drain line is run into a sink or disposer,
the drain line still must be elevated to a point higher than the highest
water level of the sink. Use the holder D, page 7.
This is to prevent back-siphoning
into the dishwasher.
CAUTION
Failure to provide the proper drain connection height (20" above
floor level with high loop or air gap) will result in improper draining
of the machine which may cause damage to the machine.
14
Publicité
