Publicité
Les langues disponibles
Les langues disponibles
* This washing
machine
is equipped
with automatic
safety functions
which detect and diagnose
problems
at an early stage and react appropriately.
When the machine
does not function
properly
or does not function
at all, check the following
points
before you call the Service Department.
• Foreign objects such as coins
or safety pins may be in drum
or pump.
Rattling and
clanking noise
Thumping sound
Vibrating
noise
Water leaks
Excessive
suds
Water does not ente
washer or it enters
slowly
Water in the washer
does not drain or
drains slowly
• Heavy wash loads may
produce a thumping
sound.
This is normal.
• Have all the transit bolts and
packing been removed?
• Wash load may be unevenly
distributed
in the drum.
• Are all the feet resting firmly on
the ground?
• Fill hose connection
is loose at
tap or washer.
• House drain pipes are clogged.
• Too much detergent
or
unsuitable
detergent.
• Water supply is not adequate
in area.
• Water supply tap is not
completely
open.
• Water inlet hose is bent.
• The filter of the inlet hose
clogged.
• Drain hose is bent or clogged.
• The drain filter is clogged.
Stop washer
and check drum
and drain filter.
If noise continues
after washer
is
restarted,
call for service.
If sound continues,
washer
is
probably out of balance.
Stop
and rearrange
wash load.
See Installation
Instructions
for
removing
shipping
bolts.
Stop washer
and rearrange
wash
load.
Adjust the leveling feet.
Make sure all four feet are in firm
contact
with the floor, while the
washer
is in the spin cycle with a
load.
Check and tighten hose
connections.
Unclog drain pipe. Contact
plumber
if necessary.
Reduce detergent
amount
or use
HE (High Efficiency)
detergent.
Designed
specially to
use only HE (High
Efficiency) detergent
Check another tap in the house.
Fully open tap.
Straighten
hose.
Check the filter of the inlet hose.
Clean and straighten
the drain
hose.
Clean the drain filter.
Publicité
