Publicité
Les langues disponibles
Les langues disponibles
* Before cleaning the washer interior, unplug the electrical power cord to avoid
electrical shock to avoid electrical shock hazards.
* When disposing of the appliance, cut off the mains cable, and destroy the plug
Disable the door lock to prevent young children being trapped inside.
• The water inlet filter
- _Eerror message will blink on the control panel when water does not enter the
detergent drawer.
- If your water is very hard or contains traces of lime deposit, the water inlet filter may
become clogged.
It is a good idea to clean it from time to time.
1. Turn off the
water tap.
3. Clean the filter
using a hard
bristle brush.
2. Unscrew the
water inlet
hose.
4. Tighten the
inlet hose.
• The drain pump filter
* The drain filter collects threads and small objects left in the laundry.
Check regularly that the filter is clean to ensure smooth running of your machine.
ACAUTION
First drain using Drain program and then open the pump filter to remove
whatever any threads or objects.
Be careful when draining if the water is hot.
* Allow the water to cool down before cleaning the drain pump, carrying out emergency
emptying or opening the door in an emergency.
1. Open the lower
cover cap (_) by
using a coin. Drain
plug (@) to pull out
the hose.
2. Unplug the drain plug (,_),
allowing the water to flow out. At
this time use a vessel to prevent
water flowing on to the floor. When
water does not flow any more, turn
the pump filter (_') open to the left.
3. Remove any foreign material
from the pump filter (,_'). After
cleaning, turn the pump filter (',_)
clockwiseand insert the drain
plug (@)to the original place.
close the lower cover cap.
Publicité
