Bartscher STM3 Mode D'emploi page 50

Display / Control elements
No.
Display/button
6
4
7
8
Device start-up
To start the device press ON/OFF button and
After starting release ON/OFF button.
Operation of the device
The device must be switched on while observing the following instructions:
1. Check power supply in the work place;
2. Check correct assembly of selected equipment;
3. Perform all checks before starting the device (table on page 45);
4. Check compliance with all safety regulations;
5. Fill appropriate container with food products;
6. Connect plug to the earthed socket with protection contact;
- 46 -
Description
Display Standby
Speed level display 1 - 9
Speed level display Turbo
ON/OFF button (designation on the motor block)
Beater Turbo button (maximum speed)
Speed increase button
Speed decrease button
button at the same time.