Publicité
Les langues disponibles
Les langues disponibles
7. Press
to switch on the dishwasher.
8. Select the desired washing program by repeatedly pressing
The corresponding programme indicator light will illuminate.
Delay Timer: The delay timer allows you to delay the start of a washing program from 1 hour up
to 24 hours.
Repeatedly press
e.g. H:03 for a 3-hour delay.
Once the delay timer has been set, close the door to activate the function.
To cancel the delayed start, open the dishwasher door and then repeatedly press
display shows "H:00".
9.
Close the door. The dishwasher will start a cycle.
10. After the program has ended, the diswasher will buzz and stop.
If the dishwasher is set for a delay start, the dishwasher will not buzz.
On the display, "0:00" will flash for a few seconds and then "End" will be displayed.
After 15 minutes, the dishwasher will turn off.
11. Wait for 15 minutes before you open the dishwasher door in order to avoid burns.
12. Unload the dishes.
WARNING!
• The washing cycle will not start if the dishwasher door is left open or not properly closed.
• Do not open the door when the dishwasher is working since hot water may be ejected, which could
cause scalding.
Adding extra dish
A forgotten dish can be added any time before the detergent dispenser opens. If this is the case, follow
the instructions below:
1. Open the door a little to stop the washing.
2. After the spray arm stops working, you can open the door completely.
3. Add the forgotten dishes.
4. Close the door. The cycle will start from the point at which it was interrupted.
until the desired delayed start time is shown on the display,
.
until the
Publicité
