Publicité
Les langues disponibles
Les langues disponibles
Starting up the device
Once the wine cabinet is properly installed, we advise that you clean the inside using warm water with a
low concentration of dish washing liquid. Do not use abrasives or scouring powder; they may scratch
the surface finish.
USAGE
CAUTION! Wine cabinets are intended only for storing and preserving wine.
IMPORTANT: Your wine cabinet is ideally suitable for holding Bordeaux type bottles of 0.75 L capacity. It
can contain larger bottles; however care must be taken that they do not prevent the door from closing
properly.
-
When closing the door ensure that it does not touch any of the bottles.
-
If you load several bottles at a time, it will take longer before the cabinet reaches the desired
temperature.
-
In order to avoid damaging the door seal, ensure that the door is fully open before moving the racks
along the compartment rails.
Adjusting the temperature
Dual zone control panel
1
1. ON/OFF button
2. ºC/ºF selector
3. Light button
4. LCD screen
POWER
- To turn the appliance off, lightly touch and hold the
until temperature display goes out. To turn the appliance on, lightly touch and hold the
second until temperature display lights up.
NOTE：Touching any key once can switch off the audible alarm when the alarm is on.
ºF/°C SELECTOR
LIGHT
- To turn the interior light on/off, lightly touch and hold the
UP
- Used to increase (warm) the set temperature by 1°C/1°F.
DOWN
- Used to decrease (cool) the set temperature by 1°C/1°F.
Setting Selector - Select the temperature you want to set.
2
3
- Set the temperature to be displayed in degree Fahrenheit or degree Celsius.
USAGE
4
5
5. Temperature & Humidity display
6. and 7. Temperature setting
8. Setting selector
6
7
8
key for 5 seconds
key for 5 seconds.
key for 1
EN-75
Publicité
