Publicité
Les langues disponibles
Les langues disponibles
Removing shelves
To remove a shelf, extend the shelf out of the rail
compartment until it stops and remove all bottles from
the shelf. Press the right slide release lever down and
at the same time lift the corresponding left slide lever
up and pull the shelf out until it is free of tracks and
the cabinet.
In order to replace the shelf, align the left and right
slide channels with the tracks in the cabinet. Ensuring
an even track engagement on both sides, gently push
the shelf into the cabinet until the tabs lock into place.
NOTE: Make sure the tabs on the full extension shelf
guides are fully engaged before loading any bottles.
Pull the shelf out all the way to the STOP position and
push back in several times to make sure locking tabs
are properly engaged.
DOOR OPENING MECHANISM (PUSH-AND-OPEN DOOR FUNCTION) (on some models)
The push-and-open door function (if your model supplied with it) is activated when the unit is powered.
To open the door, push the door slightly inwards on the top left position for the right hinge model (the
top right position for the left hinge model) and then release it again. The unit will beep once to
confirm the action. The door will be opened approx.2~7cm by the push rod. Then the door can be
fully open manually. The push rod will return to its initial position after 3 seconds automatically. And
the unit will beep once again and it is ready for next opening action.
NOTE:
-
The door will close again automatically after approx. 3 seconds if it has not been fully opened
manually for models with automatic door closing function.
-
Do not block the door or hold on it while it is opening. If the door is blocked or held during opening,
the door opening mechanism and the door will be damaged. The loud and repeated cracking noises
will be heard.
-
Do not push the push rod in or hold on to it during closing. If the push rod is blocked during closing, it
will no longer be able to reach its initial position. In the initial position, the push rod is flush with the
front of control panel. In order to set the push rod back in its initial position, disconnect the appliance
from the mains, wait for approx. 10 seconds and plug it back in again. The push rod will return to its
initial position.
-
The system is not triggered immediately after the door is closed. Allow 3 seconds and try again. This
is not a system failure.
The door on the unit is sensitive to pressure. The pressure sensitivity to open the door is possible to
adjust as following steps:
•
Open the door.
•
Rotate the screw on the top middle of door counterclockwise to
increase the sensitivity and clockwise to decrease the sensitivity.
•
Close the door and check if it is correctly adjusted. Rotating the
screw counterclockwise too much can cause the door to open
automatically even without pushing or just closing the door hard.
In reverse rotating the screw clockwise too much can cause the
door not to open even with heavy pushing.
LOADING
The maximum number of bottles that can be loaded into the cabinet are for information only; this
information is not contractual; it provides a means for rapidly estimating the size of the device.
EN-73
Publicité
