Le Chai LBN590POV Manuel D'installation page 71

If this device, which uses magnetic door closing, replaces a device equipped with a spring closing
system, we advise you to destroy the spring closing system before disposing of the old device. This
will prevent children from locking themselves inside it and endangering their lives.
Location
Place your cabinet well away from heat sources (heater, cooker, direct sunlight). For proper operation of
the device, the ambient room temperature should be between +16°C and +38°C (class ST). Outside
these limits, the device will not operate properly.
– Ensure that air can circulate freely behind the device: do not place it too close to a wall, in order to
avoid noise from vibration. Ensure that air can circulate freely all around the device. Insufficient
ventilation will lead to poor operation and increased energy consumption.
Leave at least 3 cm of empty space between the back of the wine cellar and the wall (Does not apply to
self-ventilated models).
– The device must be installed in such a way that the electric plug is accessible. After installing
the cabinet, make sure that it is not resting on the power cord.
– Level the device by using the 4 adjustable feet.
Built-in
Below the built-in dimensions to use before installing in the best condition this appliance
LBN590POV
Connecting the power supply
Your cabinet is designed for operation with 230 V single-phase.
It must be connected to a wall socket equipped with earthing and protected by a 10 A fuse in
compliance with the standard NF C15-100 and in compliance with your electricity supplier's
prescriptions.
SETTING UP THE CABINET
EN-71