FLAEM Ghibli Plus Mode D'emploi page 19

EQUIPMENT AND MATERIAL INFORMATION
The equipment includes:
Compressor unit - Model: P0211EM F400
A1 - Switch
A2 - Air intake
A -
A3 - Air filter
A4 - Nebuliser holder
A5 - Carrying handle
A6 - Power cable
Nebuliser and accessories - Model: RF6-12
B1 -Connecting tube (compressor/nebuliser unit)
B2 - RF6 Basic Nebuliser
2
B2.1 - Lower part
B2.2 - Complete nozzle
B -
B2.3 - Upper part
B2.4 - Top ventilation cap
B3 - Mouthpiece
B4 - Paediatric SoftTouch mask
B5 - Adult SoftTouch mask
C -
Accessory pouch
IMPORTANT NOTE: There is an identification label on the packaging, remove it and affix it in
the spaces provided on page 2. When replacing the Nebuliser and accessories, perform the
same procedure.
OPERATING INSTRUCTIONS
Before each use, wash your hands thoroughly and clean your appliance as described in the
section "HYGIENE PREPARATION". During application, it is recommended to adequately protect
oneself from drips. This appliance is suitable for the administration of medicinal substances
(solutions and suspensions), for which aerosol administration is envisaged; such substances
must in any case be prescribed by a doctor. In the case of substances that are too dense, dilution
with suitable saline solution may be necessary, as prescribed by a doctor.
1. Insert the plug of the power cable (A6) into a mains socket corresponding to the voltage of the appli-
ance. It must be positioned in such a way that disconnection from the power grid is not difficult.
2. Assemble the nozzle as indicated in the "Assembly diagram" in point B2.2. Insert the complete
nozzle in the bottom part (B2.1). Insert the Upper ventilation cover (B2.4) in the upper part
(B2.3) as shown in the "Connection diagram" in point B2. Pour the medication prescribed by
the physician into the lower part (B2.1). Close the nebuliser by turning the upper part (B2.3)
clockwise.
3. Connect the accessories as shown in the 'Connection Diagram' on
the cover.
4. Sit comfortably while holding the nebuliser in your hand, place
the mouthpiece to your mouth or use a nasal piece (if provided)
or mask. If you use the mask accessory, place it on your face as
shown in the figure (with or without the use of the elastic band).
5. Switch on the device by pressing the switch (A1) and inhale and
exhale deeply; after inhaling, it is recommended to hold your
breath for a moment so that the inhaled aerosol droplets can
settle. Then exhale slowly.
6. When the application is finished, switch off the device and discon-
nect it from the mains.
ATTENTION: If, after the therapy session, an obvious deposit of moisture forms inside the tube (B1),
detach the tube from the nebuliser and dry it with the ventilation of the compressor itself; this action
prevents possible mould growth inside the tube.
To facilitate the connection of the connection tube (B1) to the compressor unit, act on the end of it by
simultaneously rotating and inserting it, and for removal by rotating and extracting it.
Information on materials
Polypropylene
Polypropylene +
Thermoplastic Elastomers
19