Toro 20332C Manuel De L'opérateur page 10

Installing the Grass Bag
1. Raise and hold up the rear deflector (Figure 14).
Figure 14
1. Notches
2. Rear deflector
2. Install the grass bag, ensuring that the pins on the
bag rest in the notches on the handle (Figure 14).
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps above.
3. Grass bag pin (2)
Operating the Bag-on-Demand Lever
The bag-on-demand feature allows you to either collect
or recycle grass and leaf clippings while the grass bag
is attached to the mower.
• For bagging the grass and leaf clippings, press the
button on the bag-on-demand lever and move the
lever forward until the button on the lever pops up
(Figure 15).
1. Bag-on-demand lever (in bagging position)
• For recycling the grass and leaf clippings, press the
button on the lever and move the lever rearward
until the button on the lever pops up.
Important: For proper operation, remove any grass
clippings and debris from the bag-on-demand door
and the surrounding opening (Figure 16) before you
move the bag-on-demand lever from one position
to another.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury. Also, an open rear
discharge area could allow small stones and other
similar debris to be thrown in the operator's or
bystander's direction and result in serious personal
injury or death to the operator or bystanders.
Stop the engine and wait for all moving parts to
stop before cleaning the bag-on-demand door and
the surrounding opening.
10
Figure 15