Kohler K-792-N1 Guide De Propriétaire page 4

Activates Mode
Selected
Flow Mode
Indicator Bar -
Shows water
flow volume
Power On/Off
Operation
User Keypad
Power Turns the whirlpool pump on and off.
Indicator Bar Displays the water flow volume.
Flow Mode Allows adjustment the water flow when illuminated. Press the up or down arrow to
adjust the water flow.
Neckjet Mode Activates then neckjets at a medium pulsating speed. Press the up or down arrow to
adjust the speed.
Up Arrow Increases the water flow.
Decreases the water flow.
Down Arrow
Automatically engages when the whirlpool pump is powered on. Press the heater button
Heater
once to turn the heater off. Press the button a second time to turn the heater back on.
Whirlpool
Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.
NOTICE: Do not allow the water temperature in the whirlpool to exceed 104°F (40°C). The heater will
automatically maintain the water temperature when the whirlpool is running, as long as the water
temperature does not exceed 104°F (40°C). The heater will disengage at higher temperatures.
Close the drain, then fill the whirlpool to a level at least 2" (5.1 cm) above the highest jet. Using
your hand, test the water temperature for comfort and safety. Carefully enter the bath.
Press the power icon to turn on the whirlpool pump and heater. Water will flow at medium volume.
Press the up or down arrow icons to increase or decrease the water flow. The indicator bar will
display the water flow volume.
Adjust the jets for optimum air/water mixture. Turn the jet trim clockwise to reduce the flow or
counterclockwise to increase the flow. If desired, position the jet nozzles to direct the water flow to
maximize your hydro-massage experience.
NOTE: Before activating the neckjets, make sure the slip cover is in place on the pillow and the pillow is
attached to the neckjet body.
Rotate the outer ring to select the neckjet mode, then press OK to activate the neckjets. The neckjet
pulsing action will start at medium speed. Press the up or down arrow to adjust the pulsing action.
Rotate the outer ring until the Flow mode is flashing, the press OK. Press the up or down arrow to
adjust the water flow volume of the neckjets.
If desired, turn the heater off by pressing the heater icon. Press the button a second time to turn the
heater back on.
1018963-5-D
Increases Flow
Neckjet Mode -
Adjust Pulse
Decreases
Flow
Heater On/Off
Fill with water at least 2" (5.1 cm)
above the highest jet.
Turn the jet trim ring
clockwise to
decrease the flow.
Turn the jet trim ring counterclockwise
to increase the flow.
4
Position the jet
nozzles to direct
the water flow as
desired.
Kohler Co.