ATT Nussbaum JUMBO LIFT 3500 HFC Manuel D'exploitation page 76

Time frame Position
Type of
maintenance
12
1
11
2
10
365 x / 12
9 3
4
8
5
7
6
12
11 1
2
10
365 x / 12
9 3
4
8
5
7
6
12
1
11
2
10
1 x / 12
9 3
4
8
5
7
6
12
1
11
2
10
1 x / 12
9 3
4
8
5
7
6
12
1
11
2
10
1 x / 12
9 3
4
8
5
7
6
76
Model and information signs, labels, brief operating instructions,
safety stickers and warning information are to be cleaned and ex-
changed if damaged.
Check all available safety devices for function.
e.g.: CE stop, warning signal, blocking etc.
Exchange if damaged.
• Free the piston rod of the lifting cylinder of sand and dirt.
• Check the wiper for damage.
• Moving parts such as joint bolts and DU bearings, sliding pieces, slid-
ing surfaces and rollers are to be cleaned and checked for wear,
exchange if required.
• Lubricate all lubrication nipples with an acid-free multi-purpose
grease. Do not over-lubricate.
• Check the condition and function of the driving ramp.
• Check the condition of the cement floor.
• Check the torque of the fastening anchor. Also see the assembly
protocol.
• The condition and function of the load suspension means are to be
checked.
• Check the condition and function of all available safety devices.
All weld seams must have a visual inspection. Stop the system and
contact the manufacturer if there are cracks or breaks in weld seams
of the lift.
Check electrical components for function and condition.
• Plug.
• Operating lever with button switch.
• During assembly and maintenance always check the condition of
electrical lines. All cables and lines must be secured so they cannot
be crushed, kinked or contact any moving assembly.
Maintenance plan
OPI_JUMBO LIFT 3500 HFC_V3.0_DE-EN-FR-ES-IT