ATT Nussbaum JUMBO LIFT 3500 HFC Manuel D'exploitation page 61

2 System master sheet
2.1 Manufacturer
Nussbaum Custom Lifts GmbH
Hertz Str. 6
D-77694 Kehl-Sundheim
2.2 Purpose
The JUMBO LIFT 3500 HFC - HYMAX XX 3500 HFC lift is a lift for cars up to a total weight of 3,500 kg in normal
work shop operations and a maximum load distribution of 3:2 or 2:3 in the drive-in direction or against the
drive-in direction.
Additionally, there is a distinction between cars operated with front or rear drive.
Set up of the standard lift in explosion endangered workshops or humid work shops (e.g. outside and wash-
ing halls) is prohibited. After construction and significant maintenance changes on load carrying parts the
lift must be inspected afterwards by a specialist who approves the changes.
Operation of the lift is done by an operating unit that is located immediately next to the lift.
2.3 Changes to the design / construction
Inspections by a technical expert are required before recommissioning (date, type of change, technical
expert signature).
______________________________________________________________________________________________________
______________________________________________________________________________________________________
Name, address of technical expert
_________________________________________________
Location, date
2.4 Changing the assembly location
Inspections by a technical expert are required before recommissioning (date, type of change, specialist
signature).
______________________________________________________________________________________________________
______________________________________________________________________________________________________
Name, address of technical expert
_________________________________________________
Location, date
OPI_JUMBO LIFT 3500 HFC_V3.0_DE-EN-FR-ES-IT
_________________________________________________
Technical expert signature
_________________________________________________
Signature of Technical Expert of Safety inspections
61