Publicité
Les langues disponibles
Les langues disponibles
Maintenance and care
7.2
Trouble shooting
Fault
The product slips
The device is crooked
SAFELOCK-Mechank does not
work / not correctly
Load is not released
54500008
Cause
•
Gripper jaws/gripper claws are
worn out
•
The load capacity is greater than
permissible
→ see chapter "Authorised use"
for vitrified clay pipes
•
The wrong gripping range is set
•
The height support is set
incorrectly
•
The surface of the load is dirty
•
The product is not suitable /
permitted for this device
•
The device is loaded on one
side
•
The gripping range is not
symmetrically adjusted
•
The height support is not set
symmetrically
•
Foreign bodies in the mechanics
•
Dust or dirt in the mechanics
•
Leg spring not hooked in
•
leg spring bent / broken
•
Hook-up eyelet is in the wrong
position of the scenery
•
The dissolving power is not
sufficient
•
Foreign bodies in the mechanics
22 / 24
Remedy
•
Change gripper jaws/gripper
claws
•
Reduce load capacity
•
Adjust the gripping range to the
outer diameter of the product
•
Adjust the height support
according to the products to be
transported
•
Clean the surface of the product
from dirt
•
Consult the manufacturer to
determine whether the product is
permitted for this device
•
Focus on the product
•
Check and correct adjustment of
the gripping range
•
Check and correct the height
support setting
•
Check for possible foreign
bodies in the internal gearing
and remove them
•
Clean the mechanics with high
pressure cleaner
•
Hook in leg spring (e.g. with
pliers or screwdriver)
•
Replace leg spring (consult
manufacturer if necessary)
•
Check the position of the
suspension eye in the splitter.
To release, the suspension eye
must be in idle position (position
B, marked red).
•
Correct angle for release. See
chapter Operation "Optimum
pulling direction for opening the
device".
•
Check for possible foreign
bodies in the internal gearing
and remove them
GB
Publicité
