Publicité
English
@
@
@
]
= (2)
= (8)
:
(2)
: (8)
_=
(2)
_
: (32)
j
= (2)
@
:/4/
©
Peel and Rotate/
peler y hacer girar
©
STEP 3:
Attach
the Goal End Boards
(#6) to the Top Slat Boards
(#5)
using two Brackets
(#63) and four Screws
(#57) per Bracket.
See Fig. 3A.
Insert the two Scorers
(#39) into the Scorer
Support
(#8) and
attach the Scorer
Support
aseembly
to the Slat Top Board (#5)
using two Screws
(#60)
per Scorer
Support
assembly.NOTE:
Make sure the Scorers
(#39) are facing down when assembly.
See Fig. 3B.
Attach
the Goal End Board Assembly
(#5 and #6) to the Side
Apron's
Bushing
Block
using
four
Screws
(#56).
Attach
the
assembled
Top Slat Boards to the Side Aprons
(#1) using two
Brackets
(#63)
and four Screws
(#57) per Bracket.
See Fig.
3C.
•
Peel the protective
film off the Z-Channels
(#37), then peel the
other side backing
off the underside
of the Z-Channels
(#37).
Turn them over and carefully place them along the inside bushing
bock on the inner Side Aprons.
See Fig. 3D.
35940 wJ
(Continued on the next page.)
P. 10
@2010 Sportcraft,
Ltd.
www.sportcraft.com
Publicité
