Level Washer - Whirlpool W10410358C Instructions D'installation

LEVEL WASHER

IMPORTANT:
Leveling your washer properly reduces excess
noise and vibration.
1.
Move washer to final location
Move the washer to its final location. Rock the washer back
and forth to check whether all four feet are stable and in firm
contact with the floor. If the washer rocks, minor adjustments
may be needed to level the washer on your floor.
2.
Check levelness of washer
Check the levelness of the washer. First, place a level
on the lid near the console. Then place the level on the side
of the washer in the crease between the top of the washer
and the cabinet.
Not Level LEVEL
3.
If washer is not level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer cabinet. Then turn the
leveling foot clockwise to lower the washer or counterclockwise
to raise the washer. Recheck levelness of washer and repeat
as needed.
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer.
4.
Place level here
When washer is level, use a 9/16" or 14 mm open-end
or adjustable wrench to turn jam nuts counterclockwise
on leveling feet tightly against washer cabinet.
Place level
HELPFUL TIP: You may want to prop washer with
here
wooden block.
Not Level
Adjust leveling feet
Jam nut
Tighten leveling feet
Jam nut
9