Bosch VarioComfort TDS6080/01 Notice D'utilisation page 22

300 m l
22
B O SCH
Descaling the boiler
1 Take special care to ensure that the appliance is cold
and unplugged.
2 Empty the water tank.
3 Remove the iron from the pad (13).
4 Unscrew and remove the boiler cap (9) and take it out.
Empty the boiler completely.
5 Fill the boiler with approximately 300 ml of tap water.
Close the boiler cap and shake the base unit for a few
moments. Then, empty it completely.
Important: To obtain the best result, we recommend
that this operation be performed twice.
Before re-closing, make sure no water remains in the
boiler.
6 If your appliance is equipped with scale collector
(9*), it must be washed (see the "Descaling the scale
collector" section).
7 Replace and tighten up the cap.
Descaling the limescale collector *
1 Place the limescale collector under the water tap.
2 Wash it up until limescale residues are removed.
Descaling the iron
2"
1 Fill the tank (10) with tap water.
2 Plug in the mains cable (7) and press the button (2) to
switch the appliance on.
3 Press the descaling button (3) for 2 seconds. Its
indicator light will remain permanently lit.
* Model dependent