Publicité
Les langues disponibles
Les langues disponibles
Instructions for Proper Use and Handling
5.
Dispensing water
There are two ways to dispense water:
a.
Air Pump: lightly press on the air pump on top of lid.
b.
Auto Pump: First, press the "unlock button.
A light will go on indicating the auto pump
has been activated.
press down on the auto pump button on control panel.
*The auto pump feature will automatically shut off. This is an
important safety feature to prevent accidental dispensing of hot water.
NOTE: Water may not dispense immediately after boiling. This is normal;
please wait a couple of minutes. Do not tamper with the unit.
Do not rotate the unit while boiling.
When rotating the unit, make sure the electric cord is not
entwined with the unit, as pot may overturn.
Do not close the upper lid with excessive force, which may
cause water overflow.
Do not attempt to dispense water when unit is empty. This can
cause serious damage to the unit.
*When power is disconnected, only the Air Pump will function.
Re-boil function re-boils, or re-heats the water during Warm Mode.
When you press the Re-boil button, the Boil icon will light up
average room temperature, re-boiling takes about three minutes.
Please make sure water level is above the REFILL LINE before re-
boiling.
*The Re-Boil function will reduce chlorine content by boiling the water
longer than a conventional kettle. This will enhance the taste of the
beverage.
Cleaning and Maintenance
Please unplug and allow the unit to cool down before emptying
out water and cleaning.
When Not In Use
1.
Unplug unit and detach upper lid.
. In
Publicité
