Pur Line FRESH AIR 50 Manuel D'utilisation page 8

PARTS
OPERATION
Air Outlets
OPERATION
CONTROL PANEL
LIGHT: Press the Light button to switch on/off the air quality light and air flow indicator. This function can be used
during night, when you do not want any light to disturb your sleep.
VITA-ION: Press Ions button. The indicator will light while anion generator releasing anions.
UV: Press the UV button, the indicator will light while the UV LED is turned on.
PM2.5 Indicator function: After startup, the PM2.5 indicator will glow twinkle, 30 second later, it will show the indicator
of PM2.5 detected by sensor.
Notice: This function cannot be used as professional instrument.
FILTERS: Press this button when startup, the button lamp light, and the display will show the Residual life of filters "%".
3 seconds later, it will turn back.
When the filters need to be changed, the button lamp glow twinkle. After replace filters, press this button for 5
seconds to reset.
EN
Control panel
Air Quality Indicator Lamp
PM2.5 Sensor Cover
Power switch
Power Input Connecting Port
Back Air Inlet Duct
POWER: Press to turn on / off. The air quality indicator lamp will
light up. It will run in AUTO mode.
AUTO: Press the Auto button. The Auto indicator will glow and
the unit automatically adjust the air flow depending on the
indoor air quality. The Air Quality indicator lamp will glow to
the corresponding level of air quality.
Light Color Blue
Air quality Good
SLEEP: Press the Sleep button. The sleep indicator will light and
the air purifier will run in speed 1 – 3
AIR FLOW: Press Air Flow button, the corresponding speed
indicator will light and the air purifier will run in selected
speed. You can change the speed by pressing the airflow
selected button.
TIMER: Press the Timer button, you can set the specific time
between 0.5-24 hrs to automatically switch off the air purifier.
The set time will be indicated on the display.
6
Yellow Purple
Moderate Polluted
Red
Bad