Pkm FS2-60BBGTY Mode D'emploi page 23

Extraction mode: Install the swing check valve on the air outlet.
1. Drill the holes with a diameter of 8 mm (lock at fig.1). For drilling check the relevant
position of the screw-holes on the back of the appliance.
2. Insert the dowels in the holes.
3. Tighten the screws in the dowels.
4. Hang the appliance on the screws.
5. Extraction mode only: Install the exhaust pipe
duct or outside.
1. Drill six holes with a diameter of 4 mm into the bottom of the furniture.
2. Make a hole for the air outlet on the bottom and the top of the furniture.
3. Fix the air outlet on the hood. Fix the appliance with the 6 screws on the furniture.
4. Connect the air outlet and the air escape ( top hole) of the furniture with an exhaust
hose .
4
5. If you do not install an exhaust hose connection ( bottom hole → top hole of the
furniture), you must not block the holes. Clean the interior of the furniture regularly.
6. Fix the adjustment device on the bottom of the appliance to close the gap.
7. Extraction mode only: Make a hole at the relevant position in the top and the bottom
of the furniture. Install the exhaust pipe and lead it to a suitable exhaust air duct or
outside.
Optionally available.
3
Optionally available.
4
Installation, option 1 / wall (fig.1):
Installation, option 2 / below furniture (fig.2):
and lead it to a suitable exhaust air
3
23