FUXTEC FX-E2KS Manuel D'utilisation page 38

We recommend supporting logs to be sawn through on sawhorses. If this is not possible, the log
should be lifted and supported with the help of the supporting branches or via support blocks.
In area A, first cut to about one third of the log diameter from top to bottom, then make the final
cut from bottom to top. In area B, first cut to about one third of the log diameter from bottom to
top, then saw through from the top (see following figure).
Important: Do not saw logs that are under tension! Splintering wood or a tilted saw-bar can cause
serious injuries!
Branch removal
Always work on the side opposite the branch in question.
Start at the bottom of the log and work your way up.
Saw in the branch 10-15 cm from the base of the branch from bottom to top to 1/3 of the branch
diameter.
Saw through the branch a little further out from top to bottom.
Make a cut close to the trunk. Make the cut from top to bottom.
When delimbing lying logs, always saw off the branches that protrude freely into the air first. Do not
cut off support branches until the log has been sawn in lengths (see following figure).
Caution: Branches that are resting or under tension can wedge the saw-chain in the wood!
Maintenance and care
Attention: before any work on the power tool, remove the battery from the device.
Original manual FUXTEC FX-E2KS rev01
Sharp cutting teeth ➔ Wear protective gloves!
Do not use water or liquid detergents.
38