FUXTEC FX-E2KS Manuel D'utilisation page 34

Original manual FUXTEC FX-E2KS rev01
Switching the device on/off
Insert the batteries into the slot provided. Then push the safety button in at the side. Only then you
can operate the ON/OFF switch. The device will now start up. If you release the ON/OFF switch, the
device stops working.
Attention: The cutting tool can still run shortly afterwards.
Operating notes
WARNING!
Before each use, check that the chain brake is working properly. Otherwise, do not use the chainsaw
and have it repaired by a FUXTEC technician.
The chainsaw has a chain brake as a protective equipment, which stops the chain in a fraction of a
second in the event of a kickback. In the event of a kickback, the chain brake is automatically
activated by contact of the hand guard with the left hand. Therefore, always hold the chainsaw with
both hands.
Manual activation and release of the chain brake
Tilt the hand guard in the direction of the saw-bar tip (see following figure).
34