Bartscher Deli-Cool PRO“ 2/1 GN Mode D'emploi page 29

LED indicator lights
LED cooling indicator
This indicator lights up when the compressor is turned on,
goes out when the set inner temperature is reached, and
flashes during the delay.
LED defrost indicator
This indicator lights up during the defrost cycle,
goes out when defrost cycle is complete and flashes during
prolonged defrosting.
Switching on the device
•
Connect the device to a single grounded electrical socket.
•
Turn on the device by moving the ON-/OFF toggle switch on the operation panel
to "I" position. The red power control lamp on the right of the ON-/OFF toggle
switch lights up. The digital display shows the preset temperature and the LED
cooling indicator lights up.
Setting of the desired temperature (target value)
•
The adjustable temperature range of the device is between 2 ° C and 12 ° C.
•
To control or change the target value:
press briefly the taste
increase or decrease the value by means of a button
confirm the set temperature with the button
•
Allow the device to reach the set temperature before you put foods in GN
containers or dishes.
•
Open the sliding glass doors at the
operation side and put GN containers with
food on the bottom shelf or the prepared
small portions on plates or trays on the
intermediate shelf.
ATTENTION!
Do not put food directly on the bottom
shelf or intermediate shelf, use
appropriate containers or dishes!
- 28 -
, the set value starts to flash soon;
or , if necessary;
.